Dp Dual Trac 20 Assembly Instructions Full Best ✮ [Top-Rated]
| Problem | Likely Cause | Solution | |--------|-------------|----------| | Cable jumps off pulley | Slack cable or misrouted | Re-route cable, increase tension via turnbuckle | | Weight stack rattles | Guide rods not parallel | Loosen top brackets, shim with washers | | Adjustable arm droops | Worn locking pin or bushing | Replace pin; re-grease bushing | | Carriage doesn’t slide smoothly | Track debris or bent rail | Clean track with alcohol; check for dents | | Selector pin won’t insert | Weight plates misaligned | Stack plates again, rotating every other plate 180° |
Web: www.dpproducts.com/support Email: dualtrac@dpproducts.com Phone: 1-800-555-TRAC (8722) dp dual trac 20 assembly instructions full
: Secure these bars to the bottom piece using two carriage bolts . Use a 9/16" wrench to tighten, but leave them slightly loose until the main post is mounted to allow for adjustment. | Problem | Likely Cause | Solution |
If binding occurs: Loosen the upright bolts slightly, align the uprights exactly parallel, retighten. align the uprights exactly parallel
